Tools Required
J 24319-B
Steering Linkage and Tie Rod Puller
Removal Procedure
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Remove the tire and wheel. Refer to
Tire and Wheel Removal and Installation
.
- Remove the outer tie rod retaining nut.
Notice: Do not attempt to disconnect a steering linkage joint by driving a wedge
between the joint and the attached part. Seal damage may result which will
cause premature failure of the joint.
- Disconnect the outer tie rod from the steering knuckle using
J 24319-B
.
- Loosen the jam nut (1) and remove the outer tie rod (2) from the inner tie rod (3).
Do not reuse the jam nut.
- Inspect the shaft for bent or damaged threads.
- Clean the tapered surface of the steering knuckle.
Installation Procedure
- Lubricate the inner tie rod (3) threads with a suitable chassis lubricant before installing the outer
tie rod (2).
- Install the new jam nut (1) to the outer tie rod (2).
- Install the outer tie rod (2) to the inner tie rod (3).
- Install the outer tie rod to the steering knuckle.
Notice: Refer to Fastener Notice in the Preface section.
- Install the new outer tie rod retaining nut.
Tighten
Tighten the outer tie rod retaining nut to 60 N·m (44 lb ft).
- Install the tire and wheel. Refer to
Tire and Wheel Removal and Installation
.
- Lower the vehicle.
- Adjust the front toe. Refer to
Front Toe Adjustment
.