GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 24319-B Steering Linkage and Tie Rod Puller

Removal Procedure


    Object Number: 744327  Size: SH
  1. Remove the shock module upper retaining nuts.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tire and Wheels.

  4. Object Number: 1277999  Size: SH
  5. Remove the shock module yoke to lower control arm retaining nut.

  6. Object Number: 743091  Size: SH
  7. Remove the shock module yoke from the lower control arm using J 24319-B .

  8. Object Number: 1277174  Size: SH

    Notice: Use care when handling the coil springs in order to avoid chipping or scratching the coating. Damage to the coating will result in premature failure of the coil springs.

  9. Remove the shock module from the shock tower and lower control arm.

Installation Procedure


    Object Number: 1277174  Size: SH
  1. Install the shock module to the shock tower.
  2. Install the shock module yoke to the lower control arm.
  3. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 744327  Size: SH
  4. Install the shock module upper retaining nuts.
  5. Tighten
    Tighten the shock module upper retaining nuts to 45 N·m (33 lb ft).


    Object Number: 1277999  Size: SH
  6. Install the shock module yoke to lower control arm retaining nut.
  7. Tighten
    Tighten the shock module yoke to lower control arm retaining nut to 110 N·m (81 lb ft).

  8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tire and Wheels.
  9. Lower the vehicle.