GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 24319-B Steering Linkage and Tie Rod Puller

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.

  3. Object Number: 1277999  Size: SH
  4. Remove the shock module yoke to lower control arm mounting nut.

  5. Object Number: 743091  Size: SH
  6. Install J 24319-B to the shock module yoke to lower control arm stud.
  7. Disconnect the shock module yoke from the lower control arm using J 24319-B .

  8. Object Number: 744322  Size: SH
  9. Remove the shock module yoke to shock absorber pinch bolt and nut.

  10. Object Number: 744324  Size: SH
  11. Spread the shock module yoke at the pinch bolt using a flat-bladed tool.
  12. Remove the shock module yoke from the shock absorber.

Installation Procedure


    Object Number: 744322  Size: SH
  1. Install the shock module yoke to the lower control arm stud and shock absorber.
  2. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the shock module yoke to shock absorber pinch bolt and nut.
  4. Tighten
    Tighten the shock module yoke to shock absorber pinch bolt to 70 N·m (52 lb ft).


    Object Number: 1277999  Size: SH
  5. Install the shock module yoke to lower control arm mounting nut.
  6. Tighten
    Tighten the shock module yoke to lower control arm mounting nut to 110 N·m (81 lb ft).

  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  8. Lower the vehicle.