Adjustment Procedure
- Position the window fully up.
- Remove the door trim panel. Refer to
Door Trim Panel Replacement
.
- Remove the water deflector. Refer to
Front Side Door Water Deflector Replacement
.
- Loosen the jack screw jam nut (1).
- Adjust tip in with the jack screw (2).
| Important: One turn of the screw equals approximately
1 mm (0.04 in) change at the top of the window.
|
• | Turn the jack screw clockwise to tip the window outward. |
• | Turn the jack screw counterclockwise to tip the window inward. |
Notice: Refer to Fastener Notice in the Preface section.
- Tighten the jack screw jam nut (1).
Tighten
Tighten the jack screw jam nut to 5 N·m
(44 lb in).
- Raise the window and inspect the alignment. Repeat the procedure as necessary.
- Install the water deflector. Refer to
Front Side Door Water Deflector Replacement
.
- Install the door trim panel. Refer to
Door Trim Panel Replacement
.
- Close the door.