GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 SSR 🢒 Body 🢒 Interior Trim 🢒 Instrument Cluster Replacement

Removal Procedure
  1. Remove the instrument panel (I/P) center trim panel. Refer to Instrument Panel Center Trim Panel Replacement .

    2. Object Number: 1333064 Size: SH
  2. Remove 4 screws that retain the cluster bezel to the I/P.
  3. Partially remove the cluster bezel to gain access to the electrical connections.
  4. Disconnect the electrical connections.

Installation Procedure

    Object Number: 1333064 Size: SH
  1. Connect the electrical connections.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the cluster bezel into the I/P opening.

    3. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  3. Install the 4 screws that retain the cluster bezel to the I/P.
  4. Install the I/P center trim panel. Refer to Instrument Panel Center Trim Panel Replacement .
  5. Refer to Control Module References for programming and setup information.