GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 1251005  Size: SH
  1. Remove the rear license frame, if equipped.
  2. Remove the rear license plate.
  3. Remove the backup lamp assembly retaining screws.
  4. Partially remove the backup lamp assembly to expose the backup lamp sockets.
  5. Remove the backup lamp sockets from the backup lamp assembly.
  6. Rotate the sockets counterclockwise to release the locking tabs.

  7. Remove the backup lamp assembly from the vehicle.

Installation Procedure


    Object Number: 1251005  Size: SH
  1. Install the backup lamp sockets to the backup lamp assembly.
  2. Rotate the sockets clockwise to engage the locking tabs.
  3. Install the backup lamp assembly into position on the vehicle.
  4. Notice: Refer to Fastener Notice in the Preface section.

  5. Install the backup lamp assembly retaining screws.
  6. Tighten
    Tighten the backup lamp and rear license assembly retaining screws to 2 N·m (18 lb in).

  7. Install the rear license plate.
  8. Install the rear license frame.