Removal Procedure
- Raise the vehicle. Refer to
Lifting and Jacking the Vehicle
in General Information.
- Disconnect the electrical connector for the back lamp switch.
- Remove the retaining bolt for the back up lamp electrical connector bracket.
- Remove the backup lamp switch.
Installation Procedure
Notice: Refer to Fastener Notice in the Preface section.
- Install the backup lamp switch.
Tighten
Tighten the back up lamp switch to 20 N·m
(14 lb ft).
- Position the retaining bracket on transmission.
- Install the retaining bolt for the retaining bracket.
Tighten
Tighten the retaining bolt to 10N·m
(88 lb in)
- Reconnect the backup light switch.
- Lower the vehicle.