GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 SSR 🢒 Body 🢒 Seats 🢒 Front Seat Front Finish Panel Replacement

Removal Procedure

    Object Number: 1229816 Size: SH
  1. Remove the 2 front finish panel screws.
  2. Pull the inboard edge of the panel out to release the retaining clip.
  3. Remove the tabs from the slots in the outer trim panel.
  4. Remove the front finish panel from the seat assembly.

Installation Procedure

    Object Number: 1229816 Size: SH
  1. Align the front finish panel to the seat assembly by hooking the tabs into the slots in the outer trim panel.
  2. Align and install the inboard clip in the slot on the seat frame.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the 2 screws retaining the front finish panel to the seat assembly.

    4. Tighten
    Tighten the front finish panel screws to 1.5 N·m (13 lb in).