Tail, Marker, and License Lamps Inoperative. Chevrolet SSR 2005

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2005 🢒 SSR 🢒 Accessories 🢒 Theft Deterrent 🢒 Tail, Marker, and License Lamps Inoperative

Step	Action	Yes	No
Schematic Reference: Exterior Lights Schematics Connector End View Reference: Lighting Systems Connector End Views or Computer/Integrating Systems Connector End Views in Computer/Integrating Systems
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle in Vehicle DTC Information
2	Verify that the tail, marker and license lamps are inoperative. Do the tail, marker and license lamps operate normally?	Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems	Go to Step 3
3	Remove the park lamp relay. Ensure that the headlamp switch is in the HEAD position. Test for a ground signal at the park lamp relay control circuit terminal in the body relay block. Refer to Circuit Testing in Wiring Systems. Was a ground signal present?	Go to Step 8	Go to Step 4
4	Use the scan tool to check the body control module (BCM) park lamp switch input data. Does the scan tool indicate a park lamps ON request signal?	Go to Step 7	Go to Step 5
5	Test for an open or high resistance in the park lamp switch signal circuit. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 11	Go to Step 6
6	Inspect for poor connections at the harness connector of the headlamp switch. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 11	Go to Step 9
7	Inspect for poor connections at the harness connector of the BCM. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you find and correct the condition?	Go to Step 11	Go to Step 10
8	Replace the park lamp relay. Refer to Relay Replacement in Wiring Systems. Did you complete the repair?	Go to Step 11	--
9	Replace the headlamp switch. Refer to Headlamp Switch Replacement . Did you complete the repair?	Go to Step 11	--
10	Replace the BCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement?	Go to Step 11	--
11	Operate the system in order to verify the repair. Did you correct the condition?	System OK	Go to Step 3