Removal Procedure
Properly support the frame when you change the body mounts. If only one mount
is changed, lower the entire side on which the mount is placed in order to provide
clearance for the mount.
- Raise the vehicle slightly on a hoist. Refer
to
Lifting and Jacking the Vehicle
in General
Information.
- Place jack stands under the body on the side of the vehicle that the mounts
will be placed.
- Remove the body mount bolt, retainer, and lower cushion (1) from
the radiator support.
- Remove the body mount bolts, retainers, and lower cushions (1) from the
5 other mount locations.
- Lower the hoist enough in order to leave the body supported by the jack
stands.
- Remove the upper cushions (2) from the vehicle.
Installation Procedure
- Install the upper cushions (2) to the vehicle.
- Raise the frame slightly on the hoist.
Notice: Refer to Fastener Notice in the Preface section.
- Install the lower cushions, retainers, and bolts to the 5 body mount locations.
Tighten
Tighten the bolts to 80 N·m (59 lb ft).
- Install the lower cushion (1), the
retainer, and the bolt to the radiator support.
Tighten
Tighten the bolts to 80 N·m (59 lb ft).