GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the left instrument panel (I/P) trim panel. Refer to Instrument Panel Trim Panel Replacement - Left Side .

  2. Object Number: 1332497  Size: SH
  3. Remove 3 screws (1) retaining the knee bolster to the instrument panel.

  4. Object Number: 1332513  Size: SH
  5. Disconnect the electrical connector (2) from the headlamp switch.

Installation Procedure


    Object Number: 1332513  Size: SH
  1. Connect the electrical (2) connector to the headlamp switch.

  2. Object Number: 1332497  Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the 3 screws (1) retaining the knee bolster to the I/P.
  4. Tighten
    Tighten the screws to 2.5 N·m (22 lb in).

  5. Install the left I/P trim panel. Refer to Instrument Panel Trim Panel Replacement - Left Side .