GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Raise and support the rear axle at the designed D - height. Refer to Trim Height Specifications in Suspension General Diagnosis.

  3. Object Number: 731617  Size: SH
  4. Remove the rear axle tie rod to the axle mounting bolt and nut.

  5. Object Number: 731614  Size: SH
  6. Remove the rear axle tie rod to frame mounting bolt and nut.
  7. Remove the rear axle tie rod from the vehicle.

Installation Procedure


    Object Number: 731614  Size: SH

    Important: When installing the rear axle tie rod the bushings inner sleeve off set (largest gap) is towards the rear axle.

  1. Install the rear axle tie rod to the vehicle.
  2. Install the rear axle tie rod to frame mounting bolt and nut. Hand tighten only.
  3. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 731617  Size: SH
  4. Install the rear axle tie rod to the axle mounting bolt and nut.
  5. Tighten
    Tighten the bolts to 195 N·m (144 lb ft).

  6. Remove the rear axle support.
  7. Lower the vehicle.