Tools Required

J 24319-B Steering Linkage and Tie Rod Puller

1. Remove the shock module upper retaining nuts.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
3. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tire and Wheels.



4. Remove the shock module yoke to lower control arm retaining nut.



5. Remove the shock module yoke from the lower control arm using J 24319-B .




Notice: Use care when handling the coil springs in order to avoid chipping or scratching the coating. Damage to the coating will result in premature failure of the coil springs.

6. Remove the shock module from the shock tower and lower control arm.

1. Install the shock module to the shock tower.
2. Install the shock module yoke to the lower control arm.

Notice: Refer to Fastener Notice in the Preface section.




3. Install the shock module upper retaining nuts.

Tighten
Tighten the shock module upper retaining nuts to 45 N·m (33 lb ft).




4. Install the shock module yoke to lower control arm retaining nut.

Tighten
Tighten the shock module yoke to lower control arm retaining nut to 110 N·m (81 lb ft).

5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tire and Wheels.
6. Lower the vehicle.