Instrument Cluster Replacement for Chevrolet SSR 2006

1. Remove the instrument panel (I/P) center trim panel. Refer to Instrument Panel Center Trim Panel Replacement .



2. Remove 4 screws that retain the cluster bezel to the I/P.
3. Partially remove the cluster bezel to gain access to the electrical connections.
4. Disconnect the electrical connections.

1. Connect the electrical connections.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the cluster bezel into the I/P opening.

Tighten
Tighten the screws to 2.5 N·m (22 lb in).

3. Install the 4 screws that retain the cluster bezel to the I/P.
4. Install the I/P center trim panel. Refer to Instrument Panel Center Trim Panel Replacement .
5. Refer to Control Module References for programming and setup information.