GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 SSR 🢒 Body 🢒 Roof 🢒 Folding Top Latch Cable Adjustment - Rear

Adjustment Procedure
  1. Cycle the folding top stowage compartment lid open.

    2. Object Number: 1286888 Size: SH
  2. Stop the cycle once the folding top panels are fully retracted.
  3. Remove the upper garnish molding . Refer to Rear Upper Garnish Molding Replacement in Interior Trim.
  4. Remove the passenger side lock pillar trim. Refer to Body Lock Pillar Trim Panel Replacement in Interior Trim.
  5. Remove the passenger seat. Refer to Seat Replacement in Seats.
  6. Remove the center console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
  7. Remove the center console bracket fasteners.
  8. Disconnect all wiring connectors to the folding top.
  9. Lift the center console bracket upward and lay the center console bracket on its side in the passenger compartment.
  10. Manually cycle the folding top panels up until they are fully latched into the windshield header.
  11. Remove the body rear compartment from the folding top. Refer to Body Rear Accessory Compartment Replacement .
  12. Cycle the folding top downward to inspect the operation of the down capture latch.

    13. Object Number: 1291263 Size: SH
  13. Loosen the down capture latch cable jam nut (1).
  14. Adjust the down capture latch in or out 1 mm at a time.
  15. Cycle the folding top closed.
  16. Cycle the roof stowage compartment lid open.
  17. When the roof stowage compartment lid is fully open, inspect the down capture to see if the latch is open. Verify this by grabbing the folding top and pulling upward. If the folding top moves upward freely, the cable is adjusted properly.
  18. Repeat the adjustment as necessary.

Installation Procedure
  1. Install the body rear compartment to the folding top. Refer to Body Rear Accessory Compartment Replacement .
  2. Install the folding top wiring connectors.
  3. Install the center console bracket.
  4. Install the center console bracket fasteners.
  5. Install the center console. Refer to Console Replacement in Instrument Panel, Gages, and Console.
  6. Manually lower the folding top into the stowage compartment area.
  7. Inspect the folding top for proper operation. Refer to Power Folding Top Description and Operation .
  8. Install the passenger seat. Refer to Seat Replacement in Seats.
  9. Install the passenger side lock pillar trim. Refer to Body Lock Pillar Trim Panel Replacement in Interior Trim.
  10. Install the upper rear garnish molding . Refer to Rear Upper Garnish Molding Replacement in Interior Trim.

    11. Object Number: 1286888 Size: SH
  11. Cycle the folding top closed.