Exhaust Manifold Cleaning and Inspection. Chevrolet Silverado

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2009 🢒 Silverado - 2WD 🢒 Engine 🢒 Engine Mechanical - Hybrid (HP2) 6.0L (LFA) 🢒 Exhaust Manifold Cleaning and Inspection

Note: Do not use the exhaust manifold-to-cylinder head gaskets again. Upon installation of the exhaust manifold, install a NEW gasket. An improperly installed gasket or leaking exhaust system may affect on-board diagnostics (OBD) II system performance.

Clean the exhaust manifold (600) and heat shield (603) in solvent.

Warning: Refer to Safety Glasses Warning in the Preface section.

Dry the exhaust manifold with compressed air.
Inspect the exhaust manifold-to-cylinder head gasket surface for excessive scratches or gouging.
Inspect for a loose, damaged, or cracked heat shield (603).
Inspect the studs (605) for damaged threads.

Use a straight edge and a feeler gage and measure the exhaust manifold cylinder head deck for warpage.

An exhaust manifold deck with warpage in excess of 0.25 mm (0.01 in) within the 2 front or 2 rear runners or 0.5 mm (0.02 in) overall, may cause an exhaust leak and may affect OBD II system performance. Exhaust manifolds not within specifications must be replaced.