Front Output Shaft Drive Sprocket Bearing Replacement. Chevrolet Silverado

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2009 🢒 Silverado - 2WD 🢒 Transmission 🢒 Transfer Case - MP 1625/1626-NQF 🢒 Front Output Shaft Drive Sprocket Bearing Replacement

Callout

Component Name

•	Using the J 35512 bearing installer and an arbor press, remove the bearing assemblies from the drive sprocket.

•	Ensure the bearings are installed squarely into the drive sprocket bore.

•	Install the bearings from the top with the clutch teeth facing down.

Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Front

Tip

•	Install the bearing using the long side of the DT-48211 bearing installer .

•	Ensure the flat edge of the bearing is facing upward.

•	Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket.

•	DT-48211 Drive Sprocket Bearing Installer

•	J 8092 Universal Driver

•	J 35512 Inner Pinion Bearing Installer

For equivalent regional tools, refer to Special Tools.

Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Rear

Tip

•	Install the bearing using the short side of the DT-48211 .

•	Ensure the flat edge of the bearing is facing upward.

•	Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket.

•	DT-48211 Drive Sprocket Bearing Installer

•	J 8092 Driver Handle

•	J 35512 Inner Pinion Bearing Installer