GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2008 🢒 Silverado - 4WD 🢒 Body Systems 🢒 Fixed and Moveable Windows 🢒 Rear Sliding Window Module Replacement

Removal Procedure

    Important: The new rear sliding window motor/module is equipped with the bracket and relays.

  1. Remove the rear sliding window lower garnish molding. Refer to Rear Window Lower Garnish Molding Replacement .

    2. Object Number: 1852031 Size: SH
  2. Cycle the rear sliding window to the fully closed position.
  3. Remove the screw (1) from the rear sliding window regulator and cables (2).
  4. Pull forward on the regulator and cables (2) to release it from the motor/module.

    5. Object Number: 1852042 Size: SH
  5. Remove the rear sliding window motor/module nuts (2).
  6. Disconnect the rear sliding window electrical connectors from the motor/module and relays (1).
  7. Remove the rear sliding window motor/module assembly from the vehicle.

Installation Procedure
  1. Install the rear sliding window motor/module assembly to the vehicle.

    2. Object Number: 1852042 Size: SH
  2. Connect the rear sliding window electrical connectors to the motor/module and relays (1).

    3. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1852031 Size: SH
  3. Install the rear sliding window motor/module nuts (2).

    4. Tighten
    Tighten nut to 10 N·m (89 lb in).

  4. Install the rear sliding window regulator and cables (2) to the motor/module .
  5. Install the bolt (1) to the rear sliding window regulator and cables (2).

    6. Tighten
    Tighten bolt to 11 N·m (97 lb in).

  6. Install the rear sliding window lower garnish molding. Refer to Rear Window Lower Garnish Molding Replacement .
  7. Inspect the rear sliding window for proper operation.