Callout
| Component Name
|
1
| Transfer Case High/Low Shift Fork Pin
Tip
Drive the pin out using a drift punch and hammer. |
2
| Transfer Case High/Low Shift Fork
Tip
Inspect for wear or damage in the spring seat locations. The component must be replaced if damage is found. |
3
| Transfer Case High/Low Shift Fork Spring Assembly
Tip
The component must be replaced if the following conditions exist:
| • | The cam lobes are worn or rough |
|
4
| Transfer Case Two/Four Wheel Drive Actuator Cam Retaining Ring
|
5
| Transfer Case Two/Four Wheel Drive Actuator Cam Spacer
|
6
| Transfer Case Two/Four Wheel Drive Actuator Cam
|
7
| Transfer Case High/Low Shift Fork - Service - Pin
Tip
| • | Apply a small amount of threadlock GM P/N 12345493 (Canadian P/N 10953488), or equivalent, to the shaft of the pin before installation. |
| • | Press the pin into the control actuator shaft using a brass drift until bottom. |
|
8
| Transfer Case Shift Fork Shaft Guide Screw
Notice: Refer to Fastener Notice in the Preface section.
Tip
Apply threadlock GM P/N 12345493 (Canadian P/N 10953488), or equivalent, to the screw threads.
Tighten
5 N·m (44 lb in). |
