Sunroof Window Replacement Crew Cab

Important: The sunroof must be in the fully closed position prior to removing the sunroof window.

1. Open the sunshade panel.



2. Remove the 4 screws (2) that retain the sunroof window (1) to the sunroof module assembly.
3. Remove the sunroof window from the top of the vehicle.

1. Position the sunroof window (1) to the vehicle.
2. Loosely insert the screws (2) that retain the sunroof window (1) to the sunroof module assembly.

Notice: Refer to Fastener Notice in the Preface section.

3. Adjust the sunroof window panel as necessary. Refer to Sunroof Window Height and Opening Fit Adjustment .

Tighten
Tighten the screws to 3 N·m (27 lb in).

Sunroof Window Replacement Extended Cab

1. Position the sunshade panel fully rearward.
2. Position the sunroof window panel to the vent position.
3. Remove the sunroof window panel screws from the sunroof window panel.
4. Remove the sunroof window panel from the sunroof module.

1. Position the sunroof window panel to the sunroof module.

Ensure that the information logo stencil is towards the rear of the sunroof opening.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the sunroof window panel screws to the sunroof window panel.

Tighten
Tighten the sunroof window panel screws to 4 N·m (35 lb in).

3. Adjust the sunroof window panel as necessary. Refer to Sunroof Window Height and Opening Fit Adjustment .
4. Inspect the sunroof window panel for proper operation.