Special Tools

For equivalent regional tools, refer to Special Tools.

Note: The balance shaft and the balance shaft front bearing are serviced only as an assembly. Do not remove the balance shaft front bearing from the balance shaft.

1. Apply clean engine oil GM P/N 12345610 (Canadian P/N 993193) or equivalent, to the balance shaft front bearing.

Warning: Refer to Safety Glasses Warning in the Preface section.

2. Use the J 36996 installer and the J 8092 handle in order to install the balance shaft.

Caution: Refer to Fastener Caution in the Preface section.




3. Install the balance shaft retainer and bolts and tighten to 12 N·m (106 lb in).



4. Install the balance shaft driven gear onto the balance shaft.
5. If reusing the fastener, apply threadlock GM P/N 12345382 (Canadian P/N 10953489) or equivalent, to the threads of the balance shaft driven gear bolt.
6. Install the balance shaft driven gear bolt.

6.1.	Use a wrench to secure the balance shaft.

Place the wrench onto the balance shaft near to the balance shaft front bearing.

6.2.	Install the balance shaft driven gear bolt.

6.2.1.

Tighten the balance shaft driven gear bolt on the first pass to 20 N·m (15 lb ft).

6.2.2.

Tighten the balance shaft driven gear bolt on the final pass using the J 45059 meter an additional 35 degrees.

7. Remove the wrench from the balance shaft.
8. Rotate the balance shaft by hand in order to ensure that there is clearance between the balance shaft and the valve lifter pushrod guide. If the balance shaft does not rotate freely, check to ensure that the retaining ring on the balance shaft front bearing is seated on the case.




Note: DO NOT install the camshaft sprocket bolts at this time.

9. Install the balance shaft drive gear.



10. Rotate the engine camshaft so that the timing mark on the balance shaft drive gear is in the 12 o'clock position.



11. Remove the balance shaft drive gear.



12. Rotate the balance shaft so that the timing mark on the balance shaft driven gear is in the 6 o'clock position.



13. Position the balance shaft drive gear onto the engine camshaft.
14. Look to ensure that the balance shaft drive gear and the balance shaft driven gear timing marks are aligned.