Clutch Actuator Cylinder Replacement. Chevrolet Silverado

For 1990-2009 cars only

Makes 🢒 Chevrolet 🢒 2009 🢒 Silverado - 4WD 🢒 Transmission 🢒 Manual Transmission - Tremec 5-Speed (M96) 🢒 Clutch Actuator Cylinder Replacement

Clutch Actuator Cylinder Replacement M96

Callout	Component Name
Preliminary Procedure Remove the transmission. Refer to Transmission Replacement.
1	Clutch Actuator Cylinder Bolt (Qty: 2) Caution: Refer to Fastener Caution in the Preface section. Tighten: 8 N·m (71 lb in).
2	Clutch Actuator Cylinder

Callout

Component Name

Remove the transmission. Refer to Transmission Replacement.

Clutch Actuator Cylinder Bolt (Qty: 2)

Caution: Refer to Fastener Caution in the Preface section.

Tighten:
8 N·m (71 lb in).

Clutch Actuator Cylinder

Disconnect the clutch pedal position switch electrical connector (1).
Push the clutch pedal in and squeeze the pushrod bushing tabs in, in order to release the pushrod bushing from the clutch pedal.

Disconnect the clutch actuator cylinder to clutch master cylinder quick connect fitting.
Remove the clutch master cylinder clip from the brake pressure module valve pipe.

Rotate the clutch master cylinder 45 degrees clockwise to the unlocked position.

Push in and rotate the clutch master cylinder 45 degrees counterclockwise to the locked position.

Disconnect the clutch actuator cylinder to clutch master cylinder quick connect fitting.
Install the clutch master cylinder clip to the brake pressure module valve pipe.

Apply light pressure to the clutch pedal to couple the pushrod socket to the clutch pedal.
Connect the clutch pedal position switch electrical connector (1).
Pump the clutch pedal 3 time prior to starting the vehicle to ensure connection is complete.