GM Service Manual Online
For 1990-2009 cars only

Rear Side Door Trim Panel Replacement SLT


Object Number: 1685023  Size: MF

Callout

Component Name

Preliminary Procedure

Remove rear door window control switch. Refer to Rear Side Door Window Switch Replacement.

1

Rear Side Door Locking Rod Knob Assembly

Procedure

  1. Lower the window.
  2. Ensure the locking rod is in the unlocked position.
  3. Use a flat-bladed tool to disengage detent tab, then remove knob by pulling upward.
  4. When re-installing, push the knob down, until the detent tab touches locking rod opening cover.
  5. Push the detent tab in to lock knob to locking rod.

2

Rear Side Door Trim Panel Cover

3

Rear Side Door Trim Panel Cover Retainer (Qty: 4)

4

Rear Side Door Inside Handle Bezel Cover

5

Rear Side Door Trim Panel Bolt (Qty: 3)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
9 N·m (18 lb in)

6

Rear Side Door Trim Panel Assembly

7

Rear Side Door Cable Retainer

Tip

  1. Depress both tabs to remove cable and pull cable rearward out of handle assembly.
  2. When reinstalling cable make sure that it is fully seated past the guide tab.

8

Rear Side Door Trim Panel Retainer (Qty: 10)

Rear Side Door Trim Panel Replacement YE9


Object Number: 1824838  Size: MF

Callout

Component Name

Preliminary Procedure

  1. Remove the window control switch, if equipped. Refer to Rear Side Door Window Switch Replacement.
  2. Remove the door window regulator handle, if equipped. Refer to Door Window Regulator Handle Replacement.

1

Rear Side Door Locking Rod Knob Assembly

Procedure

  1. Lower window.
  2. Ensure locking rod is in the unlocked position.
  3. Use a flat-bladed tool to disengage detent tab and then remove knob by pulling upward.
  4. When re-installing, push knob down until detent tab touches locking rod opening cover.
  5. Push detent tab in to lock knob to locking rod.

2

Rear Side Door Release Handle Cover

3

Rear Side Door Armrest Opening Cover

4

Rear Side Door Trim Panel Bolt (Qty: 3)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
9 N·m (18 lb in)

5

Rear Side Door Trim Panel Assembly

Procedure

  1. Depress both tabs to remove cable and pull cable rearward out of handle assembly.
  2. When reinstalling cable make sure that it is fully seated past the guide tab.
  3. There are two hooks located on the lower portion of the door trim panel that are being used for manufacturing installation ONLY.
  4. If these hook are damaged during either removal or installation of the door trim panel, replacement of the panel is not required.

6

Rear Side Door Trim Panel Retainer (Qty: 10)