GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2005 🢒 Spark 🢒 Preface 🢒 Cautions and Notices 🢒 Rear Door Lock Replacement

Removal Procedure

    Caution: Refer to Battery Disconnect Caution in the Preface section.


    Object Number: 1220561 Size: SH
  1. Disconnect the negative battery cable, if equipped with the central door lock system.
  2. Remove the door trim panel. Refer to Rear Side Door Trim Panel Insert Replacement in Interior Trim.

    3. Important: In case of the deluxe type, remove the seal trim after removing the door pocket handle bracket.

  3. Remove the door seal trim (1). Refer to Door Water Deflector Replacement .
  4. Remove the door pocket handle bracket (2).

    5. Object Number: 1220564 Size: SH
  5. Remove the screw (2).
  6. Remove the guide piece (1).

    7. Object Number: 1220602 Size: SH
  7. Disconnect the outside door handle rod (1) from the door lock.

    8. Object Number: 1220604 Size: SH
  8. Disconnect the actuator connector, if equipped with the central door lock system.
  9. Remove the door lock screws (2).
  10. Remove the door lock from the vehicle (1).

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1220606 Size: SH
  1. Install the rear door lock with the screws.
  2. Connect the actuator connector, if equipped with the central door lock system.
  3. Connect the outside door handle rod to the door lock.
  4. Install the guide rail with the screw.
  5. Install the seal trim. Refer to Door Water Deflector Replacement .
  6. Install the door trim panel. Refer to Rear Side Door Trim Panel Insert Replacement in Interior Trim.
  7. Connect the negative battery cable, if equipped with the central door lock system.