GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2006 🢒 Spark 🢒 Engine 🢒 Engine Electrical 🢒 Generator Overhaul

Generator Overhaul A-Type : Mando

Disassembly Procedure

    Object Number: 1224251 Size: SH
  1. Remove the generator. Refer to Generator Replacement .
  2. Remove the front bracket and rear bracket.
  3. Remove the through-bolts (1).

    4. Object Number: 1224269 Size: SH
  4. Pry front bracket downwards using a screwdriver (1).
  5. Separate the front bracket and rear bracket (2).

    6. Object Number: 1222997 Size: SH
  6. Cover the rotor assembly with the cloth (4).
  7. Place the pulley upward and vice the rotor (3).
  8. Remove the pulley nut (2).
  9. Remove the pulley (1).

    10. Object Number: 1222998 Size: SH
  10. Remove the large collar (1).
  11. Remove the rotor from the front bracket (3).
  12. Remove the small collar from the rotor shaft (2).

    13. Object Number: 1222999 Size: SH
  13. Remove the support plate screws (1).
  14. Remove the plate (3).
  15. Remove the front bearing using the press (2).

    16. Object Number: 1223003 Size: SH
  16. Remove the battery positive terminal nut (1) from the rear bracket.
  17. Remove the washer (2).

    18. Object Number: 1223004 Size: SH
  18. Remove the rectifier screw (3).
  19. Remove the brush holder and regulator assembly screws (1).
  20. Remove the stator assembly from the rear bracket with the rectifier/brush holder/regulator (2).

    21. Object Number: 1223006 Size: SH
  21. Remove the rectifier/brush holder/regulator connections (2).

    22. Notice: If the stator connections are welded in, use just enough heat to melt the lead. Avoid using to much heat as it can damage the diodes.

  22. Remove the stator and rectifier connections (1).

Assembly Procedure

    Object Number: 1223063 Size: SH
  1. Assemble the stator assembly into the rear bracket and rotor assembly (1).
    2. • Brushes (2)
    • Hole (3)

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1223065 Size: SH
  2. Install the brush holder/regulator/rectifier screws (1).

    3. Tighten
    Tighten the brush holder/regulator/rectifier screws to 9-12 N·m (80-106 lb in).

  3. Install the battery positive terminal nut (2).

    4. Tighten
    Tighten the battery positive terminal nut to 4-7 N·m (35-62 lb in).


    Object Number: 1223066 Size: SH
  4. Install the front bearing spot plate screws (1).

    5. Tighten
    Tighten the front bearing spot plate screws to 6-8 N·m (53-71 lb in).


    Object Number: 1223067 Size: SH
  5. Install the generator pulley nut (1).

    6. Tighten
    Tighten the generator pulley nut to 80-110 N·m (59-81 lb ft).

  6. Install the through-bolts (2).

    7. Tighten
    Tighten the through-bolts to 4-6 N·m (35-53 lb in).