Removal Procedure
Caution: Refer to Battery Disconnect Caution in the Preface section.
- Disable the SIR system. Refer to
SIR Disabling and Enabling
.
Caution: The sensing and the diagnosis module (SDM) can maintain
sufficient voltage to deploy the airbags and pretensioners for up to 1 minute after
the ignition has been turned OFF and the fuse has been removed. If the airbags and
pretensioners are not disconnected, do not begin service until one minute has been
passed after disconnecting power to the SDM. Failure to do so may cause personal injury.
- Remove 3 inflatable restraint steering wheel module bolts (1).
- Disconnect the horn connector (2).
- Disconnect the inflatable restraint steering wheel module connector (3).
Caution: When you are carrying an undeployed inflator module:
• | Do not carry the inflator module by the wires or connector on
the inflator module |
• | Make sure the bag opening points away from you |
When you are storing an undeployed inflator module, make sure the bag
opening points away from the surface on which the inflator module rests.
When you are storing a steering column, do not rest the column with the bag
opening facing down and the column vertical. Provide free space for the
air bag to expand in case of an accidental deployment. Otherwise, personal
injury may result.
- Remove the inflatable restraint steering wheel module (1).
Installation Procedure
- Connect the inflatable restraint steering wheel module connector (3).
- Connector the horn connector (2).
- Install the inflatable restraint steering wheel module (1).
Notice: Refer to Fastener Notice in the Preface section.
- Install the inflatable restraint steering wheel module fasteners (1).
Tighten
Tighten the inflatable restraint steering wheel module fasteners to 12 N·m (106 lb in).
- Enable the SIR system. Refer to
SIR Disabling and Enabling
.