GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2007 🢒 Spark 🢒 Brakes 🢒 Antilock Brake System 🢒 Brake Pressure Modulator Valve Assembly Replacement

Removal Procedure

    Caution: Refer to Battery Disconnect Caution in the Preface section.


    Object Number: 1779013 Size: SH
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Disconnect the electronic brake control module (EBCM) connector (1).

    3. Object Number: 1779018 Size: SH
  3. Remove the brake pipes from the brake pressure modulator valve (BMPV) assembly.
  4. Plug the brake pipes.
  5. Loosen the mounting nuts (2) on the BPMV assembly (1).
  6. Position the brake pipes aside far enough to allow for lifting the BPMV assembly from the mounting bracket. It may be necessary to loosen the brake pipes on the master cylinder to allow for moving those pipes out of the way.
  7. Remove the BPMV assembly from the mounting bracket.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1779018 Size: SH
  1. Install the BPMV assembly (1) into the mounting bracket. Secure with 2 nuts (2).

    2. Tighten
    Tighten the nuts to 15 N·m (11 lb ft).

  2. Remove the plugs from the brake pipes and connect the brake pipes to the BPMV assembly (1).

    3. Tighten
    Tighten the brake pipe nuts to 22 N·m (16 lb ft).


    Object Number: 1779013 Size: SH
  3. Connect the EBCM connector (1).
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  5. Bleed the brake system. Refer to Hydraulic Brake System Bleeding .
  6. Perform the Diagnostic System Check - Vehicle .
  7. Refer to Control Module References for programming and setup information.