Circuit Description
This procedure checks whether the brake system has been filled and bled properly.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC C1395 Fill and Bleed Not Complete
Conditions for Running the DTC
| • | Vehicle speed is greater than 6 km/h (4 mph) with the brake pedal not applied. |
| OR |
| • | Vehicle speed is greater than 15 km/h (9 mph) and the brake pedal is actuated. |
Conditions for Setting the DTC
| • | Improper battery voltage |
| • | Brake system not properly bled |
Action Taken When the DTC Sets
The following actions occur:
| • | The antilock brake system (ABS) is disabled. |
| • | The ABS warning indicator turns ON. |
| • | The electronic brake force distribution (EBD) is disabled. |
Conditions for Clearing the DTC
The condition responsible for setting the DTC no longer exists and the scan tool Clear DTCs function is used.
Diagnostic Aids
It is very important to perform a thorough inspection of the wiring and the connectors. Failure to inspect the wiring and the connectors carefully and completely may result in misdiagnosis, causing part replacement with the reappearance of the malfunction.
Test Description
The number below refers to the step number on the diagnostic table.
Step | Action | Values | Yes | No |
|---|---|---|---|---|
Schematic Reference: Antilock Brake System Schematics Connector End View Reference: Antilock Brake System Connector End Views | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | |
Measure the battery voltage. Is the battery voltage as specified? | 11-14 V | Go to Step 3 | Go to Step 4 | |
3 | Bleed the brake system. Refer to Antilock Brake System Automated Bleed Procedure . Did you complete the repair? | -- | Go to Step 5 | -- |
4 |
Did you find and correct the condition? | -- | Go to Step 5 | Go to Step 3 |
5 |
Does the DTC reset? | -- | Go to Step 2 | System OK |
