For 1990-2009 cars only
Removal Procedure
- Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
- Disconnect the front wheel speed sensor electrical connector (1).
- Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the wheel. Refer to Tire and Wheel Removal and Installation.
- Remove the bolts (1) and the front wheel speed sensor (2) from the steering knuckle.
Warning: Refer to Battery Disconnect Warning in the Preface section.
Danger: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.
Installation Procedure
- Install the front wheel speed sensor (2) to the steering knuckle. Secure it with the bolts (1) and tighten to 23 N·m (17 lb ft).
- Install the wheel. Refer to Tire and Wheel Removal and Installation.
- Lower the vehicle.
- Connect the front wheel speed sensor electrical connector (1).
- Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
Caution: Refer to Fastener Caution in the Preface section.
