Step | Action | Yes | No |
|---|---|---|---|
Schematic Reference: Wiper/Washer Schematics Connector End View Reference: Component Connector End Views DEFINITION: This table diagnoses the rear wiper operates normally but will not return to the park position when the rear wiper switch is turned to the OFF position. | |||
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | |
2 | Verify that the rear wiper will not park when the wiper switch is turned to OFF. Does the rear wiper park? | Go to Testing for Intermittent Conditions and Poor Connections | Go to Step 3 |
3 |
Did you find and correct the condition? | Go to Step 10 | Go to Step 4 |
4 |
Did you find and correct the condition? | Go to Step 10 | Go to Step 5 |
5 | With the rear wiper relay 2 still disconnected, connect a fused jumper between the park switch circuit and the wiper motor feed circuit at the rear wiper relay 2. Does the rear wiper park? | Go to Step 6 | Go to Step 7 |
6 | Inspect for poor connections at the harness connector of the wiper/washer switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs. Did you find and correct the condition? | Go to Step 10 | Go to Step 8 |
7 | Inspect for poor connections at the harness connector of the rear wiper motor. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs. Did you find and correct the condition? | Go to Step 10 | Go to Step 9 |
8 | Replace the rear wiper relay 2. Did you complete the replacement? | Go to Step 10 | -- |
9 | Replace the rear wiper motor. Did you complete the replacement? | Go to Step 10 | -- |
10 | Operate the system in order to verify the repair. Did you correct the condition? | System OK | Go to Step 3 |
