Removal Procedure
Warning: Refer to Battery Disconnect Warning in the Preface section.
- Disconnect the negative battery cable.
- Remove the washer reservoir inlet bolt.
- Remove the washer reservoir inlet.
Danger: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the
opposite end from which the components are being removed and strap the vehicle to the hoist.
- Raise and suitable support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Remove the front RH wheelhouse splash shield screws.
- Remove the front RH wheelhouse splash shield clips.
- Remove the front RH wheelhouse splash shield.
Installation Procedure
- Install the washer reservoir assembly with the bolts.
- Connect the washer pump electrical connector.
- Connect the washer hose connector.
- Install the front RH wheelhouse splash shield with the screws and the clips.
- Lower the vehicle.
- Install the washer reservoir with the bolt.
- Connect the negative battery cable.