Release Switch Replacement for Chevrolet Tahoe 4WD - RHD 1998

1. Remove the instrument panel cluster trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Lower .
2. Remove the screws and the instrument panel switch plate from the instrument panel.
3. Disconnect the release switch electrical connector.
4. Press the tabs and remove the switch from the switch plate.

1. Install the switch into the switch plate.
2. Connect the release switch electrical connector.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the instrument panel switch plate to the instrument panel with the screws.

Tighten
Tighten the instrument panel switch plate screws to 1 N·m (9 lb in).

4. Install the instrument panel cluster trim panel. Refer to Trim Panel Replacement - Instrument Panel (I/P) Lower .