DTC P0218 Transmission Fluid Overtemperature 6.5L Diesel only
Circuit Description
The Transmission Fluid Temperature Sensor (TFT Sensor) is a thermistor that controls the signal voltage to the PCM. The PCM supplies a 5-volt reference to the sensor on circuit 1227. When the transmission fluid is cold, the sensor resistance is high and the PCM senses high signal voltage. As the fluid temperature warms to a normal transmission operating temperature, the TFT Sensor resistance becomes less and the voltage decreases to 1.5-2.0 volts.
When the PCM detects a high transmission temperature for a long period of time, then DTC P0218 sets. DTC P0218 is a type D DTC.
Conditions for Setting the DTC
| • | No TFT Sensor DTCs P0712 or P0713. |
| • | The TFT is greater than 130°C (277°F). |
| • | All conditions are met for 900 seconds. |
Action Taken When the DTC Sets
| • | The PCM freezes shift adapts from being updated. |
| • | The PCM does not illuminate the Malfunction Indicator Lamp (MIL). |
Conditions for Clearing the DTC
- A scan tool can clear the DTC from the PCM history. The PCM clears the DTC from the PCM history if the vehicle completes 40 warm-up cycles without a failure reported.
- The PCM cancels the DTC default actions when the fault no longer exists and the ignition is OFF long enough in order to power down the PCM
Diagnostic Aids
| • | The scan tool TFT Sensor temperature should rise steadily then stabilize. |
| • | Inspect for a possible torque converter stator problem. |
| • | Verify the customer's driving habits, such as trailer towing, etc . . . |
| • | First diagnose and clear any engine DTCs or APP Sensor codes that are present. Then inspect for any transmission DTCs that may have reset. |
Test Description
The numbers below refer to the step numbers on the diagnostic table.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 | Was the Powertrain On-Board Diagnostic (OBD) System Check performed? | -- | ||
2 |
Refer to Transmission Fluid Check . Did you perform the inspections? | -- | -- | |
Important: Before clearing the DTCs, use the scan tool in order to record the Freeze Frame and Failure Records for reference. The Clear Info function will erase the data. Is the TFT Sensor signal voltage less than the specified value? | 0.33 volts | Go to Diagnostic Aids | ||
Is the TFT sensor signal voltage greater than the specified value? | 4.92 volts | |||
5 |
Refer to Electrical Diagnosis, Section 8. Did you find a problem? | -- | ||
6 | Replace the PCM. Refer to Powertrain Control Module Replacement/Programming , Section 6. Is the replacement complete? | -- | -- | |
7 | In order to verify your repair, perform the following procedure:
Has the test run and passed? | -- | System OK |
