Transmission Scan Tool Data Values 6.5L Diesel
If you have completed the On-Board Diagnostic (OBD) system check, if the diagnostics are functioning properly and if no DTCs display, you may use the Typical Scan Values in the table below for comparison. These typical values are an average of display values recorded from normally operating vehicles. They represent the display from a normally functioning system.
You should never use a scan tool that displays faulty data. The condition should be reported to the manufacturer. The use of a faulty scan tool can result in misdiagnosis and the unnecessary replacement of parts.
Only the parameters listed below are used in this manual for diagnosing. If a scan tool displays other parameters, the values are not recommended by General Motors for use in diagnosis.
Scan tests are performed under the following driving conditions:
| • | Engine idling |
| • | Upper radiator hose is hot |
| • | Closed throttle |
| • | Transmission is in Park |
| • | Closed Loop |
| • | Accessories OFF |
Tech 2 Parameter | Units Displayed | Typical Scan Values |
|---|---|---|
Engine Torque | N·m (lb ft) | 29 N·m (19 lb ft) |
APP Angle | % | 0% |
Engine Speed | RPM | 620 RPM |
Transmission ISS | RPM | 700 RPM |
Turbine Speed | RPM | 700 RPM |
Transmission OSS | RPM | 0 RPM |
Vehicle Speed | km/h (mph) | 0 km/h (0 mph) |
Current Gear | 1,2,3,4 | 1 |
1-2 Sol. | On/Off | On |
2-3 Sol. | On/Off | Off |
Gear Ratio | Ratio | 8.00:1 |
1-2 Sol. Open | Yes/No | No |
1-2 Sol. Shorted | Yes/No | No |
2-3 Sol. Open | Yes/No | No |
2-3 Sol. Shorted | Yes/No | No |
TFP Sw. A/B/C | On/Off | Off/On/Off |
ECT | °C/°F | 83°C (181°F) |
Trans. Fluid Temp. | °C/°F | 48°C (118°F) |
TFT Sensor | Volts | 3.67 Volts |
Transmission Hot Mode | On/Off | Off |
PC Sol. Actual Current | Amps | 0.83 amps |
PC Sol. Ref. Current | Amps | 0.83 amps |
PC Sol. Duty Cycle | % | 43% |
TCC Brake Switch | Open/Closed | Open |
TCC Duty Cycle | % | 0% |
TCC Slip Speed | RPM | -80 RPM |
TCC Duty Cycle Open | Yes/No | No |
TCC Duty Cycle Shorted | Yes/No | No |
Latest Shift | Seconds | Varies |
1-2 Shift Time | Seconds | Varies |
2-3 Shift Time | Seconds | Varies |
3-4 Shift Time | Seconds | Varies |
Adaptable Shift | Yes/No | No |
Engine Run Time | Hour/Minutes/Seconds | Varies |
Ignition Voltage | Volts | 13.5-14.5 Volts |
Cruise | Enabled/Disabled | Disabled |
A/C Clutch | On/Off | Off |
4WD | Enabled/Disabled | Disabled |
4WD Low | Enabled/Disabled | Disabled |
Transmission Scan Tool Data Values 4.3L (G Van) 5.7L and 7.4L Gas
| Table 1: | At-1 Data List |
| Table 2: | At-2 Data List |
If you have completed the On-Board Diagnostic (OBD) system check, if the diagnostics are functioning properly and if no DTCs display, you may use the Typical Scan Values in the table below for comparison. These typical values are an average of display values recorded from normally operating vehicles. They represent the display from a normally functioning system.
You should never use a scan tool that displays faulty data. The condition should be reported to the manufacturer. The use of a faulty scan tool can result in misdiagnosis and the unnecessary replacement of parts.
Only the parameters listed below are used in this manual for diagnosing. If a scan tool displays other parameters, the values are not recommended by General Motors for use in diagnosis.
Scan tests are performed under the following driving conditions:
| • | Engine idling |
| • | Upper radiator hose is hot |
| • | Closed throttle |
| • | Transmission is in Park |
| • | Closed Loop |
| • | Accessories OFF |
Tech 2 Parameter | Units Displayed | Typical Scan Values |
|---|---|---|
Engine Torque | N·m (lb ft) | Varies |
TP Sensor | Volts | 0.59V |
TP Angle | Percent applied | 0% |
Engine Speed | RPM | 610 RPM |
Transmission ISS | RPM | 680 RPM |
Turbine Speed | RPM | 680 RPM |
Transmission OSS | RPM | 0 |
Vehicle Speed | km/h (mph) | 0 |
Commanded Gear | 1,2,3,4 | 1 |
1-2 Sol. | ON/OFF | ON |
2-3 Sol. | ON/OFF | OFF |
Gear Ratio | Ratio | 400:1 |
1-2 Sol. Open | Yes/No | No |
1-2 Sol. Shorted | Yes/No | No |
2-3 Sol. Open | Yes/No | No |
2-3 Sol. Shorted | Yes/No | No |
TFP Switch A/B/C | ON/OFF | OFF/ON/OFF |
Trans. Fluid Temp. | °C (°F) | 65°C (149°F) |
TFT Sensor | Volts | 3.02 Volts |
Tech 2 Parameter | Units Displayed | Typical Scan Values |
|---|---|---|
ECT | °C (°F) | 83°C (181°F) |
TFT Sensor | Volts | 3.02V |
Hot Mode | Yes/No | No |
PC Act. Current | amps | 0.96 amps |
PC Ref. Current | amps | 0.96 amps |
PC Sol. Duty Cycle | Percent on time | 57%/Varies |
TCC Brake Switch | Open/Closed | Closed |
TCC Duty Cycle | % | 0% |
TCC Slip Speed | RPM | -70 Varies |
TCC Duty Cycle Open | Yes/No | No |
TCC Duty Cycle Shorted | Yes/No | No |
Last Shift Time | Seconds | Varies |
1-2 Shift Time | Seconds | Varies |
2-3 Shift Time | Seconds | Varies |
3-4 Shift Time | Seconds | Varies |
Adaptable Shift | Yes/No | No |
Engine Run Time | Hr:Min:Sec | 00:00:00 |
Ignition Voltage | Volts | 13.5-14.5 |
Cruise | ENABLED/DISABLED | DISABLED |
A/C Clutch | Yes/No | No |
4WD | ENABLED/DISABLED | DISABLED |
4WD Low | ENABLED/DISABLED | DISABLED |
