GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2001 🢒 Tahoe - 2WD 🢒 Brakes 🢒 Hydraulic Brakes 🢒 Brake Pedal Replacement

Removal Procedure
  1. Disconnect the electrical connection from the stop lamp switch.

    2. Object Number: 344194 Size: SH
  2. Remove the pushrod retaining clip (4).
  3. Remove the stop lamp switch (2).
  4. Remove the pushrod (3) from the brake pedal stud (1).

    5. Object Number: 375693 Size: SH
  5. Remove the brake pedal bolt nut.
  6. Remove the brake pedal bolt.
  7. Remove the brake pedal.

Installation Procedure

    Object Number: 375693 Size: SH
  1. Install the brake pedal.
  2. Install the brake pedal bolt.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the brake pedal bolt nut.

    4. Tighten
    Tighten the bolt to 47 N·m (35 lb ft).


    Object Number: 344194 Size: SH
  4. Install the pushrod (3) to the brake pedal pin (1).
  5. Install the stop lamp switch (2).
  6. Install the pushrod retaining clip (4).
  7. Connect electrical connection to the stop lamp switch.