Recirculation Door Replacement Delphi

1. Remove the heater/vent module. Refer to Heater/Vent Module Replacement .



2. Disconnect the recirculation actuator electrical connection (1).



3. Remove the recirculation actuator mounting screws.



4. Remove the recirculation actuator.
5. Remove the recirculation door.

1. Install the recirculation door.
2. Install the recirculation actuator.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the recirculation actuator mounting screws.

Tighten
Tighten the screws to 1.9 N·m (17 lb in).




4. Connect the recirculation actuator electrical connection (1).
5. Install the heater/vent module. Refer to Heater/Vent Module Replacement .