Rear Side Door Trim Panel Replacement Tahoe/Yukon/Escalade
Removal Procedure
- Remove the door handle bezel. Refer to
Door Inside Handle Bezel Replacement
.
- Remove the window-regulator handle, if equipped. Refer to
Door Window Regulator Handle Replacement
.
- Remove the manual lock lever from the trim panel using a flat-bladed
tool.
- Remove the trim panel
screws.
- In order to remove the trim panel, slide the trim panel upward
and outward in order to release the trim panel tab retainers.
- Disconnect the electrical connectors, if necessary.
Installation Procedure
- Connect the electrical
connectors, if necessary.
Ensure that the electrical connectors
are routed through the openings.
- Align the tab retainers with the holes in the door.
- Install the trim panel to the door by lowering the trim panel
into the tab retainer holes in order to seat the retainers.
Notice: Refer to Fastener Notice in the Preface section.
- Install the 2 trim panel screws.
Tighten
Tighten the 2 trim panel screws to 2 N·m (18 lb in).
- Install the manual lock lever to the trim panel by pressing the
lever until the lever is completely seated.
- Install the window-regulator handle, as necessary. Refer to
Door Window Regulator Handle Replacement
.
- Install the door handle bezel. Refer to
Door Inside Handle Bezel Replacement
.
Rear Side Door Trim Panel Replacement Suburban/Yukon XL/Avalanche/Escld EXT
Removal Procedure
- Remove the door handle bezel. Refer to
Door Inside Handle Bezel Replacement
.
- Remove the window-regulator handle, if equipped. Refer to
Door Window Regulator Handle Replacement
.
Important: Escalade ESV - Do not remove the manual lock bezel.
- Remove the manual lock lever from the trim panel using a flat-bladed tool.
- Remove the 2 trim panel screws.
Important: Escalade ESV - Carefully lift the door trim upward making sure the trim has cleared the lock knob before sliding outward.
- Remove the trim panel from the door by carefully sliding the panel upward then outward.
- Disconnect the electrical connectors.
Installation Procedure
- Connect the electrical connectors, if necessary.
- Align the retainers with the holes in the door.
- Install the trim panel to the door by lowering the trim panel down into the retainer holes in order to seat the retainers.
Notice: Refer to Fastener Notice in the Preface section.
- Install the trim panel screws.
Tighten
Tighten the trim panel screws to 2 N·m (18 lb in).
- Install the manual lock lever by pressing the lever until the lever is completely seated.
- Install the window-regulator handle, if necessary. Refer to
Door Window Regulator Handle Replacement
.
- Install the door handle bezel. Refer to
Door Inside Handle Bezel Replacement
.