• | Twist each plug wire 1/2 turn. |
• | Pull only on the boot in order to remove the wire from the ignition coil. |
Note:
• All gasket surfaces should be free of oil an/or other foreign material during assembly. • DO NOT reuse the valve rocker arm cover gasket. • If the PCV valve grommet has been removed from the rocker cover, install a NEW grommet during assembly.
Caution: Refer to Fastener Caution in the Preface section.
Tighten
Tighten the bolts to 12 N·m (106 lb in).
Tighten
Tighten the studs to 12 N·m (106 lb in).