GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the front differential carrier shield, if equipped. Refer to Shield Replacement.
  3. Disconnect the electrical connector from the actuator.

  4. Object Number: 1690919  Size: SH
  5. Remove the actuator (1) for the 8.25 inch axle (2) or (3) for the 9.5 inch axle (4) by turning the actuator counterclockwise.

Installation Procedure


    Object Number: 1690919  Size: SH
  1. Apply sealant to the threads of the actuator (1) for the 8.25 inch axle (2) or (3) for the 9.25 inch axle (4). Use the correct sealant. Refer to Adhesives, Fluids, Lubricants, and Sealers.
  2. Caution: Refer to Fastener Caution in the Preface section.

  3. Install the actuator (1 or 3) and tighten to 20 N·m (15 lb ft)..
  4. Connect the electrical connector to the actuator.
  5. Install the front differential carrier shield, if equipped. Refer to Shield Replacement.
  6. Lower the vehicle.