Preliminary Procedures

1. Open the front door on the side the reveal molding is being serviced.
2. Pull the door auxiliary weatherstrip up to the roof header.
3. Remove the air inlet grille panel end cap.

1

Reveal Molding Nut

2

Windshield Side Reveal Molding

Tip
Upon installation, tuck the bottom edge of the reveal molding under the end cap of the air inlet grille panel prior to the screw installation.

3

Windshield Side Reveal Molding Screw (Qty: 5)

Caution: Refer to Fastener Caution in the Preface section.

Tighten
2 N·m (18 lb in)