• | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
• | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
• | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
---|---|---|---|---|
B+ | B0968 00 | 1, 2, 3 | -- | -- |
Amber 1 Indicator Control | B0968 00 | 1 | 1 | -- |
Amber 2 Indicator Control | B0968 00 | 2 | 2 | -- |
Red Indicator Control | B0968 00 | 3 | 3 | -- |
1. Amber 1 LED Malfunction 2. Amber 2 LED Malfunction 3. Red LED Malfunction |
The object alarm module directly controls the parking assist indicators located in the information center telltale assembly. The information center telltale consists of two amber and one red LED that indicate the distance of an object from the rear bumper. As objects become progressively closer to the bumper, the object alarm module will illuminate the LEDs in a sequence: one amber LED, both amber LEDs, and lastly, both amber LEDs and the red LED. The LEDs are supplied B+ by the object alarm module. Each LED is also discretely controlled by the object alarm module.
• | DTC B1325 is not set |
• | Ignition voltage is between 9-16 volts |
The object alarm module detects that one of the three indicator control circuits or the B+ circuit is shorted to ground.
• | Parking assist is disabled. |
• | The object alarm module commands the red indicator ON. |
• | The object alarm module sends a serial data message to the instrument panel cluster (IPC) to display SERVICE PARK ASSIST message in the driver information center (DIC) and a chime will sound. |
• | The DTC will transition to history when the fault is no longer present. |
• | A history DTC will clear after 100 malfunction-free ignition cycles. |
Object Detection Description and Operation
Control Module References for scan tool information
Ignition ON, command the Rear Red LED, Rear Yellow LED 1, and Rear Yellow LED 2 ON and OFF with a scan tool. The appropriate indicator should turn on and off as commanded.
⇒ | If the test lamp does not illuminate, test the B+ circuit terminal for a short to ground or an open/high resistance. If the circuit tests normal, replace the object alarm module. |
• | Amber 1 LED - terminal B |
• | Amber 2 LED - terminal C |
• | Red LED - terminal D |
⇒ | If the test lamp is always ON, test the control circuit for a short to ground. If the circuit tests normal, replace the object alarm module. |
⇒ | If the test lamp is always OFF, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the object alarm module. |
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
• | Control Module References for object alarm module replacement, setup, and programming |