Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC P1761: Up and Down Shift Switch Signal CircuitCircuit/System Description
The TAP Shift Switch Signal system allows the driver to manually shift gears by using the Upshift and Downshift positions located on the automatic transmission shift Lever. When TAP mode is selected, the shift switch input signals to the body control module (BCM). This code sets when the rolling count of the TCM does not match the same value sent from the BCM.
Conditions for Running the DTC
The engine run time is greater than 5 seconds.
Conditions for Setting the DTC
The TCM detects an error in the rolling count value that does not match with the BCM.
Action Taken When the DTC Sets
| • | DTC P1761 is a Type C DTC. |
| • | The TCM disables TAP Shift operation. |
Conditions for Clearing the DTC
DTC P1761 is a Type C DTC.
Reference Information
Schematic Reference
Automatic Transmission Controls Schematics
Connector End View Reference
Electrical Information Reference
Description and Operation
Electronic Component Description
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Testing
Ignition ON, attempt to establish communication with the BCM with a scan tool.
| ⇒ | If no communication with the BCM, refer to Control Module References for further diagnosis. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the repair.
Control Module References for control solenoid (w/body and TCM) valve assembly replacement, setup,and programming.
