• | J 24460-01 Cooling System Pressure Tester |
• | GE-48494 Power Electronics Pressure Test Adapter Kit |
Caution: The module must be drained of all residual coolant prior to disassembly. Failure to properly drain all residual coolant may cause electronic circuit damage to occur during disassembly.
Note: Place a container under the coolant outlet pipe to capture the escaping coolant.
Caution: Always remove and install the High Voltage terminal fasteners with a magnet tipped socket. Never touch the exposed electronic circuit board surface or components. Dropped fasteners or physical contact may result in electronic circuit board damage.
Caution: Refer to Fastener Caution in the Preface section.
• | If the specified pressure cannot be maintained, disassemble the drive motor generator control module assembly and replace the coolant seals. |
• | If pressure remains at the specified value, proceed to the next step. |
Caution: Always remove and install the High Voltage terminal fasteners with a magnet tipped socket. Never touch the exposed electronic circuit board surface or components. Dropped fasteners or physical contact may result in electronic circuit board damage.