Removal Procedure
- Remove the air inlet tube and resonator retaining wingnut.
- Remove the air inlet tube and resonator from the throttle body by pivoting the air inlet tube and resonator upward until the hinge clip releases from the lip on the throttle body.
- Remove the air intake resonator retainer bolt.
- Separate the air inlet duct and resonator by loosing the resonator clamp.
Installation Procedure
- Secure the resonator to the air inlet tube with the resonator clamp.
- Install the air intake resonator retainer bolt.
- Align the hinge clip with the lip on the throttle body.
- Install the air inlet tube and resonator retaining wingnut.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the clamp to 3-5 N·m (27-44 lb in).
Tighten
Tighten the bolt to 8-12 N·m (6-8 lb ft).
Install the air inlet tube and resonator to the throttle body by pivoting the air inlet tube and resonator downward until the mounting stud is through the hole in the air inlet tube.
