GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2000 🢒 Tahoe - 4WD 🢒 General Information 🢒 General Information 🢒 Shield Replacement

Removal Procedure
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.

    2. Object Number: 396828 Size: SH
  2. Remove the four bolts securing the transfer case shield to the cross member.

    3. Object Number: 396829 Size: SH
  3. Remove the four bolts securing the transfer case shield to the cross member.

Installation Procedure

    Object Number: 396828 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the four bolts securing the transfer case shield to the cross member.

    2. Tighten
    Tighten the bolts to 20 N·m (15 lb ft).


    Object Number: 396829 Size: SH
  2. Install the four bolts securing the transfer case shield to the cross member.

    3. Tighten
    Tighten the bolts to 20 N·m (15 lb ft).

  3. Lower the vehicle.