The SIR scan tool data definitions contain a brief description of all SIR related parameters available on the scan tool. The parameters that are available on the scan tool are listed below in alphabetical order.

8-Digit GM Part Number: The scan tool displays an 8-digit part number. This number is the GM part number that is stored within the SDM memory.

Active Switch: The scan tool displays enabled or disabled. The signal from the inflatable restraint IP module disable switch indicates whether the passenger frontal air bag is enabled or disabled.

ADS A/D: The scan tool displays 0-20 volts. This is the auxiliary discriminating sensor signal input to the SDM.

Calibration ID: The scan tool displays a 4-digit number. This calibration ID is the check sum of the SDM read only memory contents.

Component Serial #: The scan tool displays the digits of the SDM serial number.

Ignition Voltage: The scan tool displays 0-20 volts. Ignition represents the system voltage measured by the SDM at its ignition 1 voltage feed.

Julian Date of Build: The scan tool displays a 3-digit number. The day of the year the module was built.

Left Side Impact Sensor (SIS) / Electronic Frontal Senor (EFS) ID: The scan tool displays a 2-digit ID number. The ID signal sent to the SDM from the left SIS (utility) or the EFS (35/36 series).

LF Seat Belt Status: The scan tool displays buckled or unbuckled. The signal from the LF seat belt switch indicates whether the LF seat belt is buckled or unbuckled.

PROM ID: The scan tool displays a 4-digit number. This number is the programmable read-only memory (PROM) ID.

Right Side Impact Sensor (SIS) ID: The scan tool displays a 2-digit ID number. The ID signal sent to the SDM from the right SIS.

Year Module Built: The scan tool displays what year the module was built.