GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Chevrolet 🢒 2001 🢒 Tahoe - 4WD 🢒 Body and Accessories 🢒 Exterior Trim 🢒 Front Fender Rear Molding Replacement

Removal Procedure

    Object Number: 598807 Size: SH
  1. Remove the pushpin.
  2. Remove the bolt that fastens the molding bracket to the vehicle.
  3. Slide the molding upward in order to release the molding from the retainer.
  4. Remove the molding from the vehicle.

Installation Procedure

    Object Number: 598807 Size: SH
  1. Install the molding, ensuring that the inner side of the molding lip seats in the retainer.

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the bolt.

    3. Tighten
    Tighten the bolt to 25 N·m (18 lb ft).

  3. Install the pushpin.