GM Service Manual Online
For 1990-2009 cars only

SMU - Revised DTC P2135

Subject:Revised DTC P2135

Models:2003 Cadillac Escalade, Escalade ESV, Escalade EXT
2003 Chevrolet Avalanche, Silverado, Suburban, Tahoe, TrailBlazer, TrailBlazer EXT
2003 Chevrolet W-Series Medium Duty Tilt Cab Models
2003 GMC Envoy, Envoy XL, Sierra, Sierra Denali, Yukon, Yukon XL, Yukon Denali
2003 GMC W-Series Medium Duty Tilt Cab Models
2003 HUMMER H2



This bulletin is being issued to revise Step 4 of DTC P2135 in the Engine Controls-4.8L, 5.3L and 6.0L sub-section of the Service Manual. Please replace the current information in the Service Manual with the following information.

The following information has been updated within SI. If you are using a paper version of this Service Manual, please make a reference to this bulletin on the affected page.

Step 4 now includes the use of jumper wires.

Step

Action

Yes

No

4

  1. Remove the air inlet duct from the throttle body.
  2. Disconnect the throttle body harness connector.
  3. Connect the jumper wires between the TP sensor terminals of the throttle body harness connector and the corresponding TP sensor terminals of the throttle body.
  4. Observe the TP sensor 1 and 2 with a scan tool.
  5. Slowly open the throttle blade to wide open throttle (WOT) and back to the closed throttle position several times by hand.

Does the TP sensor Agree/Disagree parameter change from Agree to Disagree during the above test?

Go to Step 18

Go to Diagnostic Aids