Tools Required

J 45756 Output Shaft Seal Installer

1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
2. Remove the rear propeller shaft. Refer to Rear Propeller Shaft Replacement in Propeller Shaft.
3. Remove the rear output shaft seal by prying it out with a flat-tipped screwdriver.

1. Using the J 45756 , install a NEW output shaft seal.
2. Install the rear propeller shaft. Refer to Rear Propeller Shaft Replacement in Propeller Shaft.
3. Check the fluid level. Add fluid if necessary.
4. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .