• | J 8433 Two Jaw Puller |
• | J 41558 Crankshaft Sprocket Remover |
• | J 41816-2 Crankshaft End Protector |
• | J 42386-A Flywheel Holding Tool |
Important:
• Do not use the camshaft position (CMP) actuator solenoid valve again. Upon installation of the CMP actuator and timing chain, install a NEW valve. • Do not apply threadlock to the flex plate bolts at this time.
Notice: Refer to Fastener Notice in the Preface section.
Tighten
Tighten the
J 42386-A
bolts to 50 N·m (37 lb ft).
Caution: Refer to Camshaft Position Actuator Removal and Installation Caution in the Preface section.